The Crystal Water Effect Resin
In cases of strict necessity, it is advisable to unify, before ‘use, the components and then mix the resin following the following ratio
100:40 by weight (100 gr. resin + 40 gr. hardener), pay attention to ‘air that can be incorporated creating annoying bubbles (which you can avoid by manually mixing very gently..
The mixture obtained , should be poured into a mold. We recommend that you work the mold with silicone release agent or waxy release agent.
Casting can take place in cavities of any material, when the resin starts to solidify, you can opt for creating waves, ripples, or, you can decide to soften it with a stove or a hair dryer. the reaction time of the mixture is about 12 hours, and this allows you to make castings even of considerable volume, up to 2-3 cm. thick at once.
Resin should preferably be stored in a dark, cool, dry place and at temperatures not exceeding 25°C. If the storage temperature is below 10°C, the resin (component A) may become whitish and thicken. In this case, to restore the original state of the resin, we recommend heating it to a temperature of 50-60°C for a few minutes.









Reviews
There are no reviews yet.